![]() Confirm that duckbill valves are oriented in the correct position see assembly instructions on page 9 for guidance. Check duckbill valves for any damage or wear. Low or no suction Make sure your pump is turned on and the suction level is set properly. Replace the membranes if needed and clean/replace the tubing. If condensation occurs, ensure tubing is dry before next use: Disconnect the tubing from cups and turn the pump back on to dry the tubing while you are storing your breastmilk Milk in tubing Check the membranes for damage. TROUBLESHOOTING Issue Solution Condensation in tubing Ensure the tubing, the silicone membranes, and membrane caps are dry before use. MEDELA Lactina, Symphony, Pump in Style Advanced, Pump In Style with MaxFlow, Sonata, Freestyle, Freestyle Flex, Swing Maxi, Swing In order to maximize suction, using your existing pump’s tubing may be preferable to using Legendairy Milk’s Y-shape tubing *Please note: For the following breast pumps, you must use the connector to cap closed one of the pump ports:Īmeda Finesse, Purely Yours or Purely Yours Ultra, Ardo Calypso, Evenflo Advanced Tip! When pouring your milk, use your thumb to squeeze the breast shield to control flow.ĪMEDA Mya, Mya Joy, Finesse, Purely Yours, Purely Yours Ultra.Carefully remove the cups from your bra and place them on a flat, firm surface until you’re ready to transfer your milk.INSTRUCTIONS FOR USEĬorrect nipple alignment and a supportive bra that keeps the cups securely in place will ensure your pumping sessions are comfortable and effective.ĭouble check that you have a good seal between the funnel and your skin. Handwash or use UV sterilization or cold water sterilization after first use. Otherwise, the parts will be damaged and the suction and fit will be affected. ![]() Do not steam sterilize or dishwash parts at any point. *After first sanitizing all parts (except tubing and plastic cups), please do not boil silicone parts again. Use large pot to prevent parts from touching sides or bottom of pot.Submerge parts (except tubing, adapters, and plastic cups) in a pot of water and boil for a maximum of 3 minutes.Follow cleaning instructions 2.a through 2.e.Valves can be cleaned by gently rubbing between fingers.Disassemble all other parts (collection cup, silicone breast shield, valve and valve base).When used correctly, tubing does not come in contact with breastmilk and does not need to be cleaned Put aside parts that don’t come in contact with breast milk.Shake off excess water and air-dry on a dedicated rack or clean cloth. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |